Agar 3D Gloss Floor Finish
- High scratch repair
- Stays shiny longer
- For both gas and electric buffing machines
- Excellent for supermarkets and heavy-traffic floors.
Agar 3D-GLOSS is a super-glossy sealer finish for vinyl, timber and stone floors. It is designed with a fast cure-rate for use in supermarkets where it buffs up easily under UHS buffing machines to provide a crystal-clear, dazzling gloss. Agar 3D-GLOSS dries to form a colourless, tough modified acrylic, a metal cross-linked film which has an outstanding gloss level and a very high degree of scratch repair when burnished. Floors coated with 3D-GLOSS achieve peak gloss after only one or two buffs and they retain their sparkle through the day because of the high abrasion resistance of the new polymer. 3D-GLOSS also offers the possibility of being buffed by gas or electric buffers due to its high burnish response.
Colourless, non-slip and mark resistant.
For use on:
3D-GLOSS should be used on vinyl tiles, sealed timber, sealed terrazzo, sealed marble, terracotta, slate, linoleum, and brick floors.
Colour: Milky white liquid
Odour: Faint ammonia
pH: 8.5 –9
Coverage: 50 -80 sq metres per litre
Slip Resistance: 3D-GLOSS passes the Slip Resistance Test under dry conditions as specified in AS/NZS 4586-1999. It gives a mean Dynamic Coefficient of friction of 0.70 which is well above the minimum requirement of 0.40
Directions for use:
Remove adhesive, build-up sealer or wax and other soilage using Agar ULTRA STRIP, TAKE-OFF or STR-36. New floors should always be stripped prior to sealing. Whilst a new floor looks clean, it is covered in a protective film added at the time of manufacture. New floor sealer will not adhere to this film, so it must be stripped.
Flood-rinse floor to remove the stripper and dirt. The floor must be well covered in clean water. Mop up or wet-vac and allow to dry. If the floor is vinyl, burnish floor then fringe mop to remove dust. Do not burnish bare terrazzo or stone floors.
Apply 2 thin basecoats using either a fringe mop or bucket mop. (Note: on floors which take heavy traffic, Agar MASTERPIECE is recommended for vinyl tiles and Agar FIRST BASE for marble and terrazzo. For an extra high gloss, the floor may be buffed when these first 2 coats are dry.) Check that the base coats are tack-free before applying 2 coats of 3D-Gloss, making a total of 4 coats.
After 2 to 7 days, apply 2 more coats of 3D-GLOSS. This film of 6 coats will provide a sound foundation for protecting the flooring and will give an excellent depth of shine.
For the first week, soft buffing pads (such as champagne) must be used. After this period, Jackeroo Lite or other UHS pads can then be used for burnishing.
Maintain floor by cleaning with Agar AUTOSCRUB, SYMPOL or SCRUB ‘N’ SHINE then dry buffing or spray buffing. Softer pads with no natural hair-fibres are preferred.
Re-coat heavy traffic areas when required. This will ensure a shiny, beautiful and long-wearing coating.
Worn films may be scrubbed off using Agar FLORPREP at 1:20 with blue pads and may then be recoated with 3D-GLOSS after buffing and sweeping.
Do not apply any sealer to a very cold floor (9ºC or less). If the application is unavoidable in very cold or humid weather, lay very thin coats one hour apart.
Bulk Buying Is Available, Get In Touch With Us Today To Find Out More.
|Dimensions||31 × 19 × 11 cm|